Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic .25/20 SS cases with LR primer (Read 1930 times)
Spud
Ex Member


.25/20 SS cases with LR primer
Feb 25th, 2005 at 6:07pm
Print Post  
I found a part box (45) of old WRA co. .25/20 SS cases on a dealers table. They were in excellent unfired condition and on closer examination I found that they had LR primer pockets. I'm going to clean them up and use them in my Low wall. Is there any advantage in using the LR primer instead of the usual SR with this case? Anybody had experience with these before?  I'll probably start with a L pistol primer (Rem 21/2).
Spud
  
Back to top
 
IP Logged
 
PETE
Ex Member


Re: .25/20 SS cases with LR primer
Reply #1 - Feb 25th, 2005 at 10:13pm
Print Post  
Spud,

   I don't see any advantage to using LR primers in that small a case. Possibly of some use back in the early smokeless days when some shooters even used BP as a priming charge because the early smokeless powders were hard to ignite.

  When using the LP primers just be sure they don't sit to deep into the case. If they do then the primers will set back into the breech face, and in time will create a "pocket". If this "pocket" gets to deep it could interfere with opening the action, or in a worst case break the firing pin.

  The LP primer idea is good if the above problem doesn't occur since the use of a LR primer will probably be strong enuf to give varying degrees of push to the bullet before ignition get properly underway, which isn't good for accuracy.

PETE
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint