ASSRA Forum › General › Reloading the Single Shot Rifle › Weighing Cases?
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Weighing Cases? (Read 3469 times)
AzShooter
Ex Member


Weighing Cases?
Oct 26th, 2004 at 2:19pm
Print Post  
Is weighing your case before starting to load important?

I recently decided to switch to Winchester Cases and after enlarging the primer pockets and deburring the holes I weighed each case.   Of the 150 cases 80 turned out to be 162 grains.  62 cases are 161 grains.   Three were only 160 and 5 were 163 grains.

I'm thinking of mixing the 161 and 162 grain cases together.  Is that good enough or should I separate them.  The light and heavy cases will be used just for dumby rounds.
  
Back to top
 
IP Logged
 
First_Shirt
Ex Member


Re: Weighing Cases?
Reply #1 - Oct 26th, 2004 at 2:53pm
Print Post  
Personally, I wouldn't cull any til I'd fireformed and trimmed them all to the same length.  Then weigh and segregate.  I have found weighing cases to help in the case of very small cases (.223), not so much with cases of larger capacity.

FWIW,
Greg
  
Back to top
 
IP Logged
 
mes
Senior Forum Member
****
Offline



Posts: 492
Location: Wisconsin
Joined: Apr 17th, 2004
Re: Weighing Cases?
Reply #2 - Oct 26th, 2004 at 5:45pm
Print Post  
I would shoot them to see how they group.  Any case that has a shot out of the group could be segregated and if it does it a second or third time squash it.
  
Martin Stenback
Back to top
 
IP Logged
 
joeb33050
Frequent Elocutionist
*****
Offline



Posts: 2613
Location: Marathon, FL
Joined: Apr 20th, 2004
Re: Weighing Cases?
Reply #3 - Oct 28th, 2004 at 5:42am
Print Post  
I uniform primer pockets, de-burr flash holes, trim after firing, anneal, turn some case necks (including straight) and weigh/segregate. I don't know that any step makes a difference but believe that doing it all makes a difference, and eliminates any question about the brass.
joe b.
  
Back to top
 
IP Logged
 
Brent
Ex Member


Re: Weighing Cases?
Reply #4 - Oct 28th, 2004 at 7:46am
Print Post  
AZ - I think that's good enough.  I got anal and weighed all my .45-100 brass to 0.1 gr lots and then cut index notches on the rim to identify each weight class.  I don't know that it mattered to the targets, but I slept better.

Brent
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9612 seconds.