ASSRA Forum › General › Reloading the Single Shot Rifle › Smokeless in the 25/20SS
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Smokeless in the 25/20SS (Read 8664 times)
MerwinBray
Oldtimer
*****
Offline


Aw Gees

Posts: 938
Location: Kansas City, KS
Joined: Apr 17th, 2004
Smokeless in the 25/20SS
Apr 22nd, 2004 at 7:09am
Print Post  
I have the original 25/20 ss barrel that was on my 44.5 when I got it. I did a little shooting with it with black and with the now defunct Goex Clear Shot. It shot pretty nice with both. I was reading the Schuetzen Rifles book by Kelver. It mentions in the loading section loading the 25/20 with unique. I use this powder for several other things but am wondering if anyone could recommend other smokeless loads for this round safe in that gun, the 44.5. I have read that XMP5744 is very versitle and I use it in a 45-70. Could it be used in the smaller cartridge? Can most loads for the 25-20 WInchester be safley used in a 25-20SS? Better yet, can some one tell me of a source of loading info for the 25/20ss?
Jon
  
Great Plains Precision Rifle Club
Back to top
 
IP Logged
 
PETE
Ex Member


Re: Smokeless in the 25/20SS
Reply #1 - Apr 22nd, 2004 at 10:21am
Print Post  
Jon,
  I am assuming your rifle has the old standard 1-14" twist and if so I can't help you much with smokeless loads for your .25/20SS as both my 44 1/2 and Low Wall had 1-10" twist barrels on them and didn't shoot the 75 & under gr. bullets that you need very well.

  As for using .25/20 WCF loads in the SS, Waters shows in his book that the WCF case has a water capacity of 26 grs. and the SS has one of 30 grs., so loads for the WCF should be ok in the SS. This will assume of course that you are going to use only cast Lead bullets.

  The only smokeless powder I used was 4227 and with bullets of suitable wgt. for my twist would shoot about 3/4", 5 shot groups at 100 yds., so might be a powder to try.

PETE
  
Back to top
 
IP Logged
 
waterman
Frequent Elocutionist
*****
Offline



Posts: 2845
Location: Behind the Redwood Curtain
Joined: Jun 9th, 2004
Re: Smokeless in the 25/20SS
Reply #2 - Jun 18th, 2004 at 1:45am
Print Post  
I shoot Unique in my Stevens 44 action .25-20 SS.  I use a 1:20 Lyman 85 gr. bullet lubed with SPG and 5.0 grains Unique.  I breech seat the bullet.  Seems to be a very mild load, which I think is a must for those who bang away with the 44 action.  5 grains is probably a good starting point.
  
Back to top
 
IP Logged
 
Asst
Ex Member


Re: Smokeless in the 25/20SS
Reply #3 - Jun 18th, 2004 at 7:32am
Print Post  
94 gr bullet
AAC-9 8.4 gr.   Aprox  1,676 fps
SR-4759 8.5 gr    "      1,557fps

105 gr bullet
AAC-9 8.2 gr      "   1,587
AAC-9 8.4          "   1,622 fps

H-4227 8.1         1,458


108 gr bullet
SR-4759  9.0 gr   1,547
H-4227    8.1   1,449

Also IMR 4227 works well. 9.0 grs upto  10.5 grs.

Velocities will change with different primers.

The lighter bullets do not work as well as the 100 gr 105 gr bullets. So if possible find a 100 gr bullet or as heavey there abouts as you can.

The  100 to 108gr  can be shot from a 12 or 10 twist and be fine. You'll find bullets upto .990 long, stable to 200yds  from a 12 twist.

At 100 yds you can expect groups .275" to around .590.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6631 seconds.